David D asked:


1. In direct torque amplifiers (transistor pair), how can I reduce the interference of RF ( "product; Blast" sounds during operation in mains AC or AC equipment such as light pipe)? It is the chief problem being wrong in this kind of amplifiers. 2nd It is the above problem may persist in the type of MOSFET amplifiers? 3rd Today, because the series is highly expensive - preferred the common PN junction transistor? You can give the advantages and disadvantages of the transistors of Darlington?

Willie asked:


what? the difference between the pre amp? king and the power amp? king?

CanadianGuitar asked:


Let the fight begin! Im definitely a purist tube haha. I do not think just the conditions of the solid; respond "to the nuances of your game as well. They are not even medium-term nature and the distortion of the ss amps have is through the transistors. The distortion of the tubes is just soo sweet to its hard describe. The Web that DI has run in jcm2000 a marshall halfstack that runs through the carriage 1960A with celestions. the whole tone of the pipe.

bruvvamoff asked:


So are more susceptible to damage other amps so I thought that the identification sure. For the defective amps use a few times in a day and a switch it out of jams? More like that you should connect / disconnect league. The dealer said the disconnection by a first, but my friend says to switch it off first, another kind that turned the guitar down first, which is it? And what is the difference between 'master' and 'volume'? The more there anything else I should know about tube amps? Thank you

howdy2bub asked:


the amplifier tube 25 watts you? set of speakers should I choose this? that? pi? easy to push the 4 or 6 Ohm 0hm. thanks.

harish asked:


iam a freak low I want to know the model numbers and prices of the amplifiers, basstube that if I use it for the better bass.

Dan L asked:


From what we understand? a filament that? somewhat heated. Then download a cloud of electrons in a vacuum and moving positively towards the metal plate loaded by a -? And something about the grid between the control the movement of electrons? Where the original signal from the guitar enters? Where exits? As the filament? heated? I also noticed that? are typically four poles that sit out from the bottom, what everyone does? Moreover,? across a closed circuit correct? I 'M under the impression that in the current flow passes through the filament, gets transferred to the plate and then it leaves the flat where? Where to go from l? and the pipe? feels like the 'missing / misunderstanding of m. something. I 'm. also still a bit disconcerting as to which party amplifies the signal. ? the grid? ? the signal from the guitar and the electron current through the separate property of the filament is a two or the same? If separated, leaving the audio signal from the guitar enters and exits?

bob s asked:


I run my guitar into an instrument of the pre amps on a PreSonus fp10. I was drilling rig guitar work in my PA system but the sound was iffy, I have taken the direct primary on PreSonus and I operated on my guitar amp and the sound was INCREDIBLE. I just wanted to know if there is a risk of burst my amps which makes this method. If it helps to have a way of egnater ribelle 2x12 with the pipes.

nootgis asked:


what type of your favorites? Why? What is a tube amplifier for $ 300 - $ 400? I want to know what your opinions are, because so many other people has as much experience and knowledge about guitars and amplifiers.

thanr asked:


The 60 watt amps combined sell for around $ 500. I 'the VE has seen it used for 300. That seems too inexpensive for a really good amps tube makes me wrong? The pro players out there who have used them?